Plastic Overmold Lines

Started by MBecker32, June 16, 2015, 12:13:19 PM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

MBecker32

How do I get rid of the lines that are running through the overmold? I am just using a polypro plastic (hard) and an overmold ,but I end up with unrealistic looking lines in the overmold? What are these from and how do I remove them?

TpwUK

Looks like two surfaces sharing the same space, check your model in those areas that are 'lined' and make sure there are no extra surfaces that shouldn't be there.

Martin

MBecker32

This worked. All I had to do was offset by .001" in the Y-Direction to remove these lines. Thanks!

TpwUK

You're welcome - Glad it worked :)

Martin