In KeyShot 6, our company was scaling parts to a distance of '15', so we could use various rendered parts on quote drawings, PowerPoint presentations etc. without the need to then scale the parts and hope you have the right size relative to one another. If you remember, the 'Distance' did not necessarily have any units associated with it. When I open an existing file in KeyShot 7, that was created in KeyShot 6, it shows a 'Distance' of 8" instead of the 15 (with no units) we were accustomed to (this is not the problem). When I import the same file, from CREO into KeyShot 7 and set the 'Distance' to 8" our part size becomes much smaller and is not the same scale. I have attached two pictures to show the difference. Is there a way to change the 'Distance' back to what it was in KeyShot 6 or is there some conversion factor? We have rendered thousands of parts to scale and to do this all over again would be a nightmare.