Hello,
I have one question regarding the function "Edit geometry". If you have an assembly consisting of 11 parts but 10 of these are of the same kind and want to do edit geometry on these 10 parts. Can you do this simultaneously in some way so you don't have to do "edit geometry" on all parts individually? This would save a lot of time :)
Thank you!
Not at this time. Edit Geometry is only one part at a time. Head over to the wish list Forum and drop a note in there!
Thank you for your answer!
It was a pity that this function is not available, but then I know that I do not have to look for it :)