Print Page - SolidEDGE ST4 (ASM/STEP) -> KS3

Title: SolidEDGE ST4 (ASM/STEP) -> KS3
Post by: yoyer on October 06, 2012, 05:30:21 AM

Hello everyone,

I have somekind of issue. I'm importing a file from SolidEdge ST4 to KeyShot 3. I'm using assembly file or STEP file and I have disconnected surfaces and awfull shadows.
Please look at this picture - this is a render of this model. Model is with lot of rounds.

What can I do to remove this?

Title: Re: SolidEDGE ST4 (ASM/STEP) -> KS3
Post by: guest84672 on October 07, 2012, 07:03:06 AM

Looks like your tessellation is too low - increase the tessellation under the advanced tab in the import dialog box.

Also, why are you not using the native SE file?

Title: Re: SolidEDGE ST4 (ASM/STEP) -> KS3
Post by: yoyer on October 07, 2012, 08:27:38 AM

Same thing happens when I'm using SE .asm file; but what is interesting this "scratch" is only on right side of this model, other side is same modeled but there is everything ok :(

KeyShot Forum

Technical discussions => Data Import => Topic started by: yoyer on October 06, 2012, 05:30:21 AM