Print Page - Unable to import SolidWorks 13 into KS 4.1.35

Title: Unable to import SolidWorks 13 into KS 4.1.35
Post by: Speedster on June 26, 2013, 05:00:53 PM

Yikes! Unable to import any SolidWorks 2013 models into 4.1.35, by any of the available import methods- plugin (crashes SW), DnD, or either import option in an open .bip. "Contains no 3D geometry

Title: Re: Unable to import SolidWorks 13 into KS 4.1.35
Post by: Speedster on June 26, 2013, 06:48:04 PM

Did a full uninstall and a clean install directly from the 4.1.35 download. No luck, except now I can import SolidWorks parts, but it crashes with assemblies. Anybody else having this problem? I have to render a big job in the AM, but right now I'm dead in the water.
Bill G

Title: Re: Unable to import SolidWorks 13 into KS 4.1.35
Post by: NDenekamp on June 26, 2013, 06:54:11 PM

Do you have another CAD application you can use to transfer through?

Does no cad file open? Does something off grab cad work?

Previous versions are available here http://www.keyshot.com/previous-keyshot-versions/ but this hasn't been updated to include the 4.0 release! perhaps 3.3 would suffice for this urgent job?

I'm sure the 4.0 build is still available from somewhere..

N

Title: Re: Unable to import SolidWorks 13 into KS 4.1.35
Post by: keaneray on June 26, 2013, 08:52:12 PM

I just imported a SW13 assembly into KS 4.1 via the plugin with no problem. Do you have the latest plugin installed for SW?

Ray

(http://i44.tinypic.com/123s2tk.jpg)

Title: Re: Unable to import SolidWorks 13 into KS 4.1.35
Post by: DriesV on June 26, 2013, 11:50:35 PM

No problem here either with SW13 & KS4.1.

Dries

KeyShot Forum

Technical discussions => General discussion => Topic started by: Speedster on June 26, 2013, 05:00:53 PM