Print Page - Cannot get rid of Flyaway Fibers

Title: Cannot get rid of Flyaway Fibers
Post by: HaroldL on January 08, 2020, 08:13:11 PM

OK so I sent a sample part from Alibre Design to KS 9.1. Went through the Unwrapping process and applied some RealCloth material. It looked pretty good except that I could not adjust the parameters of the Flyaway fibers. Not only that, when I applied a different material the Flyaway fibers remained. ???
I can see no way of removing them even with multiple material changes.

Title: Re: Cannot get rid of Flyaway Fibers
Post by: Sune on January 09, 2020, 01:16:05 AM

Hi.

The Flyaway fibers will stay until you execute the geometry node. In the top right corner of the real-time view you should see the icon I attached.
If you click it, the Flyaway fibers will update.

Title: Re: Cannot get rid of Flyaway Fibers
Post by: HaroldL on January 09, 2020, 08:11:41 PM

Thanks, I guess I should have read the manual. :-[

KeyShot Forum

Archive => KeyShot 9.1 Beta Discussion => Topic started by: HaroldL on January 08, 2020, 08:13:11 PM