KeyShot Forum

Share => Materials and Textures => Topic started by: jmfit on July 05, 2010, 08:48:37 pm

Title: Standard Glass
Post by: jmfit on July 05, 2010, 08:48:37 pm
Hi all-
I've imported this cone from SW and applied the standard glass material to it. It's rendering with some jagged edges on the inside of the cone.  Is there a correct setting to get the edges to appear smoother?

Thanks--
Joe
Title: Re: Standard Glass
Post by: David on July 06, 2010, 02:58:34 am
check the image quality / tessellation in SW?

Tools / options / Document Properties / image quality. increase the values to achieve a smoother model.
Title: Re: Standard Glass
Post by: jmfit on July 06, 2010, 06:24:21 pm
David-
Thanks--
I had this peice in an assembly and cranked up the image quality of the individual part to the max. It still was looked the same.
Figured out you can't adjust the assembly file quality. Saved the entire assembly as a single part with the quality set all the way up. Now it looks much better!!

Thanks again!!

Joe