Hi I'm a fairly new user of KS2 and am having problems scaling my bumpmap past the threshold of 5 even if I key in another value it will not scale past a certain point and therefore will not cover my surface entirely,
Any ideas??
Thanks
I'm an "old" user with the same problem, and it also applies making it smaller than "0". I usually go back and resize the jpeg up or down to get within range. It would be great if scaling were infinite.
Bill G
Yes - it is a limitation right now. Fixed in 2.1.
QuoteFixed in 2.1.
You guys are great! Have we told you that lately?
Bill g
Thanks Bill ;-) - getting all teary-eyed ...
Thanks for your suggestions, I did try scaling the jpeg up but to no avail. How do you scale it up, increase the canvas/image size but keep the same dpi?
look forward to V2.1
QuoteHow do you scale it up, increase the canvas/image size but keep the same dpi?
Check "Resample Image", leave it at 300 dpi (or whatever) and chose a new size.
Bill G
Hi Bill G,
I tried that as well with no luck!! very frustrating. When is 2.1 being released?
Any other ideas?
Thanks again,
Lance.
End of September.
Gradually it's getting tight, that version 2.1 will be released in September.
Is there a new release date?
Regards, DonChunior
There are a few days left in September will we be expecting 2.1 in the next few days?
We are trying hard ...