KeyShot Forum

Technical discussions => General discussion => Topic started by: Robert V. on October 12, 2010, 12:22:22 PM

Title: Solidworks color assignment
Post by: Robert V. on October 12, 2010, 12:22:22 PM
Hi all,

I made a very big object in SW2010. A lot of the small details had to be a different material... So I went ahead to change every surface to a different color.

After importing the model into keyshot I found out that some parts were linked. So apparently I have selected to same colour multiple times! (by accident) But the parts are in a different color-group (in SW).

Now I was wondering if it would be possible in the future to have KS look at the color-groups and not at the exact colours. (could have saved me a lot of time)

with kind regards,
R.