Remove ends of cylinder label

Started by Yabusa, April 19, 2020, 09:53:00 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Yabusa

Is there a way to remove the flat ends of a cylindrical label?
The can has a rounded bottom, so the label is covering the inside as well

Don Cheke

Quote from: Yabusa on April 19, 2020, 09:53:00 AM
Is there a way to remove the flat ends of a cylindrical label?
The can has a rounded bottom, so the label is covering the inside as well

Does splitting surface not work for you, where you can then just add a different material on the bottom?

Don Cheke

Quote from: Don Cheke on April 19, 2020, 11:29:41 AM
Quote from: Yabusa on April 19, 2020, 09:53:00 AM
Is there a way to remove the flat ends of a cylindrical label?
The can has a rounded bottom, so the label is covering the inside as well

Does splitting surface not work for you, where you can then just add a different material on the bottom?

Or add a separate surface in your modeling program and assign different material.

Yabusa

That would work, thanks for the suggestion

INNEO_MWo

Use a color fade node as a clipping mask in the opacity channel of the label material. Or split the surfs.