Plastic Overmold Lines

[MBecker32]

How do I get rid of the lines that are running through the overmold? I am just using a polypro plastic (hard) and an overmold ,but I end up with unrealistic looking lines in the overmold? What are these from and how do I remove them?

[TpwUK]

Looks like two surfaces sharing the same space, check your model in those areas that are 'lined' and make sure there are no extra surfaces that shouldn't be there.

Martin

[MBecker32]

This worked. All I had to do was offset by .001" in the Y-Direction to remove these lines. Thanks!

[TpwUK]

You're welcome - Glad it worked

Martin