Curved Glazing creates Clipping to objects behind

Started by mariomarimba, December 28, 2015, 03:58:03 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

mariomarimba

Hi
I am an architect .had KS-3,-4 and 5.  Never had any issue until this recent one with KS-5.
there is some strange clipping that curved glass causes to objects behind.
I model in Moi 3 and Rhino 5.
My Comp is Dell 5810 tower.
Intel(R) Xeon(R) CPU-E5-1630 v3
Graphics card Nvidia Quadro k 4200
I have tried FBX, OBJ, STEP but cliiping is allways there.
however recently i modelled a little experimental car and rendered in KS-5 and none of the above problems occur .
interestingly enough when i open the same model in KS-4 I HAVE NO PROBLEMS AT ALL.
So I am rendering at the moment my architectural models in KS -4.
I AM ON WINDOWS 7

THANKS REGARDS
 

mariomarimba

key shot team

is there anybody who can look into this matter?

thanks

PhilippeV8

Are you sure the geometry behind does not touch the glass ... even if 0.01mm sepparation between the 2 planes could maybe fix this.  Give it a try.

mariomarimba


Speedster

Is the glazing "glass" single or two-sided?
Bill G

mariomarimba

speedster

thanks for response.  Glass is not assigned as double sided.  It just had thickness of 30 mm.
however similar clippings occur on another model I can't post.  That model has no glass and clippings occur when i change perspective to 21.  it looks like large ball of nothing in the middle.  the problem is such that i have to resort back to KS 4 that works fine.  it does not show this problem with the same model imported.

thanks

PhilippeV8

If you move the camera, does the clipping change ?

mariomarimba

I just imported model as nurbs from MOI directly and clipping has not occured.  I shall keep monitoring and posting outcomes.
thanks for all comments.

Niko Planke

We solved this issue via Mail.

In this case the scaling of the model was wrong.(A factor of approximately  10000 to small)

By scaling the model up to a realistic size the clipping could be avoided.