Is it possible to set Rounded Edges angle value below 30?

[cro]

Been looking everywhere for this but I can't seem to find anything. It is a bit annoying because my model contains alot of edges which are below 30 deg.
Is this limitation hardcoded due to prevent any rendering issues or there are some tricks to disable it?

[Will Gibbons]

Been looking everywhere for this but I can't seem to find anything. It is a bit annoying because my model contains alot of edges which are below 30 deg.
Is this limitation hardcoded due to prevent any rendering issues or there are some tricks to disable it?

To my knowledge there is no way around it. I'd recommend modeling any fillets you may need if it's crucial for your rendering.