Author Topic: Applying a bump through curvature mask ?  (Read 7583 times)

0 Members and 1 Guest are viewing this topic.

Offline DriesV

  • Administrator
  • Hero Member
  • *****
  • Posts: 2542
  • Total likes: 38
  • Product Specialist at Luxion
Re: Applying a bump through curvature mask ?
« Reply #15 on: September 29, 2017, 02:02:37 am »
Hi Esben,

It is quite similar, but the limitation in your setup is that the (exact) bump height is hard to control. The Height will also be limited to a maximum of 1, since the maximum value (brightness) of a texture is 1.
You would need to add a 'Color To Number' node in between the Curvature texture and the Noise texture, in order to control/extend the Bump Height.

Dries
« Last Edit: September 29, 2017, 02:07:51 am by DriesV »

Offline Esben Oxholm

Re: Applying a bump through curvature mask ?
« Reply #16 on: September 29, 2017, 03:24:10 am »
It is quite similar, but the limitation in your setup is that the (exact) bump height is hard to control. The Height will also be limited to a maximum of 1, since the maximum value (brightness) of a texture is 1.
You would need to add a 'Color To Number' node in between the Curvature texture and the Noise texture, in order to control/extend the Bump Height.

Okay, cool. Thanks for the clarification.

Offline DMerz III

Re: Applying a bump through curvature mask ?
« Reply #17 on: September 29, 2017, 07:12:26 am »
 :) That makes sense, thank you!