Author Topic: Standard Glass  (Read 3259 times)

0 Members and 3 Guests are viewing this topic.

Offline jmfit

Standard Glass
« on: July 05, 2010, 08:48:37 pm »
Hi all-
I've imported this cone from SW and applied the standard glass material to it. It's rendering with some jagged edges on the inside of the cone.  Is there a correct setting to get the edges to appear smoother?

Thanks--
Joe

Offline David

Re: Standard Glass
« Reply #1 on: July 06, 2010, 02:58:34 am »
check the image quality / tessellation in SW?

Tools / options / Document Properties / image quality. increase the values to achieve a smoother model.

Offline jmfit

Re: Standard Glass
« Reply #2 on: July 06, 2010, 06:24:21 pm »
David-
Thanks--
I had this peice in an assembly and cranked up the image quality of the individual part to the max. It still was looked the same.
Figured out you can't adjust the assembly file quality. Saved the entire assembly as a single part with the quality set all the way up. Now it looks much better!!

Thanks again!!

Joe