Bumpmap scaling problem

Started by lancemcgregor, September 14, 2010, 12:52:27 PM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

lancemcgregor

Hi I'm a fairly new user of KS2 and am having problems scaling my bumpmap past the threshold of 5 even if I key in another value it will not scale past a certain point and therefore will not cover my surface entirely,
Any ideas??
Thanks

Speedster

I'm an "old" user with the same problem, and it also applies making it smaller than "0".  I usually go back and resize the jpeg up or down to get within range.  It would be great if scaling were infinite.
Bill G

guest84672

Yes - it is a limitation right now. Fixed in 2.1.

Speedster

QuoteFixed in 2.1.

You guys are great!  Have we told you that lately?
Bill g

guest84672

Thanks Bill ;-) - getting all teary-eyed ...

lancemcgregor

Thanks for your suggestions, I did try scaling the jpeg up but to no avail. How do you scale it up, increase the canvas/image size but keep the same dpi?
look forward to V2.1

Speedster

QuoteHow do you scale it up, increase the canvas/image size but keep the same dpi?
Check "Resample Image", leave it at 300 dpi (or whatever) and chose a new size.
Bill G

lancemcgregor

Hi Bill G,
I tried that as well with no luck!! very frustrating. When is 2.1 being released?
Any other ideas?
Thanks again,
Lance.

guest84672


DonChunior

Gradually it's getting tight, that version 2.1 will be released in September.
Is there a new release date?

Regards, DonChunior

lancemcgregor

There are a few days left in September will we be expecting 2.1 in the next few days?

guest84672