KeyShot Forum

Technical discussions => General discussion => Topic started by: HaroldL on June 25, 2019, 08:25:41 pm

Title: Wavy Edge Section
Post by: HaroldL on June 25, 2019, 08:25:41 pm
I wanted a cutaway section of a model but instead of straight edges I want it to have wavy edges to simulate a break out section you see on an engineering drawing. So I applied a Noise texture map the Displace node of a Rounded Rectangle then changed the material type to Cutaway. It does give some interesting results.
Title: Re: Wavy Edge Section
Post by: Bruno F on June 26, 2019, 04:04:05 pm
Hello Harold,

Thank you for posting. It looks pretty good. Do you need assistance with anything?
Title: Re: Wavy Edge Section
Post by: HaroldL on June 26, 2019, 06:19:26 pm
Hello Harold,

Thank you for posting. It looks pretty good. Do you need assistance with anything?
When I started on this little project KeyShot crashed on me and I sent in the crash report that popped up. After a restart everything worked out okay. So no assistance is needed with this mode. I just wanted to share the technique.