KeyShot Forum

Technical discussions => General discussion => Topic started by: shkiimaa on July 12, 2021, 05:04:35 AM

Title: How can I set the shadow of the polycarbonate label?
Post by: shkiimaa on July 12, 2021, 05:04:35 AM
I put a polycarbonate case on the AirPods Pro.

label on the AirPods case, the shadow does not appear underneath the label and is displayed on the back of the object.

Give me a solution.

Title: Re: How can I set the shadow of the polycarbonate label?
Post by: INNEO_MWo on July 12, 2021, 10:22:46 PM
This is the same issue like the ,,two sided labels" on bottle renders (typically). So the forum search will show you plenty of solutions and example scenes.
Is the a gap between the air pod case and the transparent case?


CheerEO
Marco

P.S. written in short form on a mobile device
Title: Re: How can I set the shadow of the polycarbonate label?
Post by: shkiimaa on July 14, 2021, 10:25:24 PM
Quote from: INNEO_MWo on July 12, 2021, 10:22:46 PM
This is the same issue like the ,,two sided labels" on bottle renders (typically). So the forum search will show you plenty of solutions and example scenes.
Is the a gap between the air pod case and the transparent case?


CheerEO
Marco

P.S. written in short form on a mobile device
Yes, when the AirPods case and AirPods were overlapped, it came out black, so there was a gap between the two.