Cylinder mapped label depth?

[JGulliford]

Hi, I have a label wrapped around a glass bottle using the cylinder mapping tool, but the label is projected onto the inner surface of the glass.

I'm aware of the 'depth' label property, but this isn't active and is 'greyed out' when in the cylindrical mapping tool, if I switch to another mapping method it becomes active again. Is this a bug or is there another way to get rid of the second label projection?

Many Thanks

[Chad Holton]

Change the color of the inside (or outside) of the bottle before exporting to have separate control over the surface inside.

[edwardo]

Or.... Create (offset) a surface a fraction of a mm outside the bottle to put the label on. This way you get full control over the material and finish of the label (foil/paper/inked/ embossed etc)

Ed

[Chad Holton]

Or.... Create (offset) a surface a fraction of a mm outside the bottle to put the label on. This way you get full control over the material and finish of the label (foil/paper/inked/ embossed etc)

Ed

Oh yes, the good ol' offset surface trick... nice!