Bumpmap scaling problem

[lancemcgregor]

Hi I'm a fairly new user of KS2 and am having problems scaling my bumpmap past the threshold of 5 even if I key in another value it will not scale past a certain point and therefore will not cover my surface entirely,
Any ideas??
Thanks

[Speedster]

I'm an "old" user with the same problem, and it also applies making it smaller than "0".  I usually go back and resize the jpeg up or down to get within range.  It would be great if scaling were infinite.
Bill G

[guest84672]

Yes - it is a limitation right now. Fixed in 2.1.

[Speedster]

Fixed in 2.1.

You guys are great!  Have we told you that lately?
Bill g

[guest84672]

Thanks Bill ;-) - getting all teary-eyed ...

[lancemcgregor]

Thanks for your suggestions, I did try scaling the jpeg up but to no avail. How do you scale it up, increase the canvas/image size but keep the same dpi?
look forward to V2.1

[Speedster]

How do you scale it up, increase the canvas/image size but keep the same dpi?

Check "Resample Image", leave it at 300 dpi (or whatever) and chose a new size.
Bill G

[lancemcgregor]

Hi Bill G,
I tried that as well with no luck!! very frustrating. When is 2.1 being released?
Any other ideas?
Thanks again,
Lance.

[guest84672]

End of September.

[DonChunior]

Gradually it's getting tight, that version 2.1 will be released in September.
Is there a new release date?

Regards, DonChunior

[lancemcgregor]

There are a few days left in September will we be expecting 2.1 in the next few days?

[guest84672]

We are trying hard ...