Author Topic: Allen&Heath Mixer  (Read 964 times)

0 Members and 1 Guest are viewing this topic.

Offline raffaprado

Allen&Heath Mixer
« on: January 28, 2019, 07:35:49 am »
What's up Keyshoters! Here is my last personal work, I used Fusion 360 and Keyshot, hope you guys like it. Any question, comments, tips it's very welcome. Thanks!

Offline Will Gibbons

Re: Allen&Heath Mixer
« Reply #1 on: January 28, 2019, 09:33:57 am »
Wow! Looks like lots of time went into this. Was the model very heavy in KeyShot? Also, did you make all the labels too? Impressive.

Offline raffaprado

Re: Allen&Heath Mixer
« Reply #2 on: January 29, 2019, 12:34:14 am »
Wow! Looks like lots of time went into this. Was the model very heavy in KeyShot? Also, did you make all the labels too? Impressive.

Thanks, Will. Yes, it was a little heavy for my i5 laptop, but a little patience and everything end up well. Yes I did the labels too, I try at first to use the high quality picture from the real product but it turns out very bad, so I had to spend a few minutes on illustrator.

Here's a picture with the labels.

Offline Will Gibbons

Re: Allen&Heath Mixer
« Reply #3 on: January 31, 2019, 02:06:18 pm »
Wow. That would take me more than a few minutes :) Very well-done!