Author Topic: Looking for a solution for live-linking Inventor assemblies  (Read 726 times)

0 Members and 1 Guest are viewing this topic.

Offline mpraska

Looking for a solution for live-linking Inventor assemblies
« on: February 11, 2020, 06:49:21 am »
Has anyone found some type of workaround to live-link Inventor assemblies? The engineers here all use Inventor/Vault to create projects. My issue is that every time they make a change I have to start all over again in KeyShot after importing the assembly. I'm looking into saving the project as a Fusion 360 file and using the Fusion 360 plugin to open in KeyShot, so far not a lot of success...

I'm open to trying some convoluted process to get it to work in a live-linking scenario because these projects are quite complex and it can take days to process an update when it should only take minutes...

Thanks community for any assistance,
Mike

Offline INNEO_MWo

  • Hero Member
  • *****
  • Posts: 1157
  • Total likes: 44
  • Senior Technical Consultant @ INNEO (Germany)
    • german KeyShot page from INNEO Solutions
Re: Looking for a solution for live-linking Inventor assemblies
« Reply #1 on: February 11, 2020, 11:51:46 am »
Does a sat file work for you?