Started by ajayre, August 22, 2022, 04:38:35 PM
0 Members and 1 Guest are viewing this topic.
Quote from: mattjgerard on August 23, 2022, 07:20:27 AMYep, common problem. The depth is your savior, make sure its on Plane mapping mode, turn off 2 sided and both H and V repeat, and set the depth to something small but not zero. Then you have to use the Move Label tool and make sure the plane of the label is in line and on top of the surface you want the label to be on. Don't use Box mapping. If you click on the little target icon in the move tool pallet, this will allow you to click on the sirface and dynamically click and drag the label to where you want it, then scale and rotate it from there. But the target mode will pop it right to the surface that you need.