Author Topic: UV Unwrap Keyshot v9.3.14  (Read 295 times)

0 Members and 1 Guest are viewing this topic.

Offline Mads Hall

UV Unwrap Keyshot v9.3.14
« on: October 16, 2022, 06:09:40 am »
Hello.

I'm having issues when trying to UV unwrap my model.
For the straight parts there are no issues, but when the model bends, it's like the UV does not really know what to do.

Please refer to the pictures below.
the model is made in Fusion 360.

Does anyone know what I could be doing wrong here?

Offline Anindo Ghosh

Re: UV Unwrap Keyshot v9.3.14
« Reply #1 on: October 16, 2022, 09:08:47 am »
Just as an experiment, could you try defining the first seam at the outer side of the curved edge, rather than the inner side?

Offline Mads Hall

Re: UV Unwrap Keyshot v9.3.14
« Reply #2 on: October 16, 2022, 09:25:30 am »
Hi Anindo,

I don't use the seam option, but the green line i believe you refer to is the directions guide.
This photo is with the direction guide on the outer edge.

Offline INNEO_MWo

  • Hero Member
  • *****
  • Posts: 1327
  • Total likes: 85
  • Senior Technical Consultant @ INNEO (Germany)
    • german KeyShot page from INNEO Solutions
Re: UV Unwrap Keyshot v9.3.14
« Reply #3 on: October 17, 2022, 10:09:49 am »
I would try to retesselate the part before UV unwrap

Offline Mads Hall

Re: UV Unwrap Keyshot v9.3.14
« Reply #4 on: October 17, 2022, 11:24:49 am »
I tried that a few times with different imputs without any luck. I guess I just have to keep trying different approaches.