Author Topic: "milky foil"  (Read 2765 times)

0 Members and 1 Guest are viewing this topic.

"milky foil"
« on: December 03, 2018, 03:39:46 pm »
Is there a way to create such a "milky foil" as shown in the attached picture? Im grateful for your help.

Offline bdesign

Re: "milky foil"
« Reply #1 on: December 03, 2018, 04:10:14 pm »
I'd recommend using the Plastic (Cloudy) material type, and make sure your sheet has some actual thickness (volume).


Offline INNEO_MWo

  • Hero Member
  • *****
  • Posts: 1135
  • Total likes: 39
  • Senior Technical Consultant @ INNEO (Germany)
    • german KeyShot page from INNEO Solutions
Re: "milky foil"
« Reply #2 on: December 05, 2018, 09:36:17 am »
I would start with the advanced material, black as diffuse and light grey in the transmission channels with a small roughness value on top and a high roughness in the transmission.

That should work fine and way faster then cloudy plastic (sorry Eric).

May share your test results and scene?!

Hope that helps