Remove ends of cylinder label

[Yabusa]

Is there a way to remove the flat ends of a cylindrical label?
The can has a rounded bottom, so the label is covering the inside as well

[Don Cheke]

Is there a way to remove the flat ends of a cylindrical label?
The can has a rounded bottom, so the label is covering the inside as well

Does splitting surface not work for you, where you can then just add a different material on the bottom?

[Don Cheke]

Is there a way to remove the flat ends of a cylindrical label?
The can has a rounded bottom, so the label is covering the inside as well

Does splitting surface not work for you, where you can then just add a different material on the bottom?

Or add a separate surface in your modeling program and assign different material.

[Yabusa]

That would work, thanks for the suggestion

[INNEO_MWo]

Use a color fade node as a clipping mask in the opacity channel of the label material. Or split the surfs.