Author Topic: Remove ends of cylinder label  (Read 4193 times)

0 Members and 1 Guest are viewing this topic.

Offline Yabusa

Remove ends of cylinder label
« on: April 19, 2020, 09:53:00 am »
Is there a way to remove the flat ends of a cylindrical label?
The can has a rounded bottom, so the label is covering the inside as well

Offline Don Cheke

  • Jr. Member
  • **
  • Posts: 66
  • Total likes: 6
  • Provider of Comprehensive TurboCAD Tutorials
    • Textual Creations
Re: Remove ends of cylinder label
« Reply #1 on: April 19, 2020, 11:29:41 am »
Is there a way to remove the flat ends of a cylindrical label?
The can has a rounded bottom, so the label is covering the inside as well

Does splitting surface not work for you, where you can then just add a different material on the bottom?

Offline Don Cheke

  • Jr. Member
  • **
  • Posts: 66
  • Total likes: 6
  • Provider of Comprehensive TurboCAD Tutorials
    • Textual Creations
Re: Remove ends of cylinder label
« Reply #2 on: April 19, 2020, 11:46:31 am »
Is there a way to remove the flat ends of a cylindrical label?
The can has a rounded bottom, so the label is covering the inside as well

Does splitting surface not work for you, where you can then just add a different material on the bottom?

Or add a separate surface in your modeling program and assign different material.

Offline Yabusa

Re: Remove ends of cylinder label
« Reply #3 on: April 19, 2020, 11:53:37 am »
That would work, thanks for the suggestion

Offline INNEO_MWo

  • Hero Member
  • *****
  • Posts: 1327
  • Total likes: 85
  • Senior Technical Consultant @ INNEO (Germany)
    • german KeyShot page from INNEO Solutions
Re: Remove ends of cylinder label
« Reply #4 on: April 21, 2020, 01:40:41 pm »
Use a color fade node as a clipping mask in the opacity channel of the label material. Or split the surfs.